Publicité
Les langues disponibles
Les langues disponibles
ÉPIX™ Strip 2.0 QRG
Mounting
The ÉPIX™ Strip 2.0 comes with an adjustable mounting bracket and safety loop. The
mounting bracket has three 13-mm holes used to attach a clamp directly to the product's
adjustable bracket, and serves as support for either mounting on the floor or on the wall.
The safety loop is used to attach a safety cable.
You must supply your own clamps and make sure the clamps are capable of supporting
the weight of this product. Before mounting the product, read and follow the safety
recommendations indicated in the
clamps, go to trusst.com/productcategory/base-plates-accessories-clamps/.
Mounting Guidelines
CHAUVET® recommends using the following guidelines when mounting this product:
·
Before deciding on a location, always make sure there is easy access to the
product for maintenance and programming.
·
Make sure that the structure or surface onto which you are mounting the product
can support the product's weight (see the
·
When mounting the product overhead, always use a safety cable. Mount the
product securely to a rigging point, such as an elevated platform or a truss.
·
When rigging the product onto a truss, you should use a mounting clamp of
appropriate weight capacity.
·
The bracket adjustment knobs allow for directional adjustment when aiming the
product to the desired angle. Only loosen or tighten the bracket knobs manually.
Using tools could damage the knobs.
·
When mounting the product on the floor, make sure that the product and cables
are away from people and vehicles.
Mounting Instructions
1.
Attach the clamp to the mounting bracket.
2.
Attach the clamp to the desired structure or surface.
3.
Attach a safety cable to the product's safety loop.
Page 6
All manuals and user guides at all-guides.com
Safety
Notes. For our CHAUVET® line of mounting
Technical
Specifications).
ÉPIX™ Strip 2.0 QRG Rev. 2
EN
Publicité
