Télécharger Imprimer la page

HOMCOM 800-103V80 Manuel D'assemblage Et D'instructions page 4

Publicité

Les langues disponibles

Les langues disponibles

The handblender is perfectly suited for preparing dips, sauces, soups, mayonnaise and baby
food as well as for mixing and milkshakes. In addition , the handblender E' can crush ice.
1
.
Turn the blender stick on the motor unit until it locks.
2. Introduce the hand blender in the vessel. Then choose speed to operate it. The direction
of the arrow shown in Figure transferred at high speed, just the opposite direction was to
adjust the low-speed
3 Turn the blender stick off the motor unit after use.
.
You can use the hand blender in the measuring beaker and just as well in any other
vessel.
4. Use the handblender for no longer than 1 minute
5. Caution:the blade is very sharp!
6. Caution: Don't operate food without water!
How to use the chopper
1. Chopper is perfectly suited for hard food, such as chopping meat, cheese, onion, herbs,
garlic, carrots, walnuts, almonds, prunes etc.
2. Don't chop extremely hard food, such as ice cubes, nutmeg, coffee beans and grains.
Before chopping...
1. Carefully remove the plastic cover from the blade. Caution: the blade is very sharp!
Always hold it by the upper plastic part.
2. Place the blade on the center pin of the chopper bowl. Press down the blade and lock
bowl. Always place the chopper bowl on the anti-slip base.
3. Place the food in the chopper bowl.
4. Place the chopping bowl lid on the chopper bowl.
5. Turn the motor unit on the chopping bowl lid until it locks.
6. Choose speed
processing, hold the motor unit with on hand and the chopper bowl the other.
7. After use, turn the motor unit off the chopping bowl lid.
8. Then remove the chopping bowl lid. carefully take out the blade.
9. Carefully take out the blade.
10. Remove the processed food from the chopper bowl.
11. Don't operate hard food for no longer than
12. Don't operate food without water than 5 second.
13. When you are operating , you should use the low gear.
and press switchⅠor switchⅡ to operate the chopper. During
10
seconds.
3
EN

Publicité

loading