Publicité
Les langues disponibles
Les langues disponibles
BASIC INSTALLATION
Selecting the placement of your new SX Coaxial speakers could be as easy as
using the existing factory locations or may require you to create a new location.
Speaker placement in the door, dash, or rear deck is the most common. See
your local Phoenix Gold Dealer for additional location and mounting assistance.
DOORS /REAR DECK
1. M any vehicles already have factory locations (Figure 1) to house the "DROP
IN" feature of the SX Coaxial speakers. If no existing locations are available
or are not used, check the desired location for adequate cutout area and any
depth obstructions. Make sure to allow sufficient clearance for window tracks,
structural braces, trunk lid springs, etc.
2. A ssuming enough area and depth is available, use the provided template
and trace the speaker cutout and mounting holes onto the surface of the
mounting location.
3. I f the mounting surface is not structurally strong enough to accommodate
screws, (i.e. plastic, cardboard) use the pro vided speed clips which will act
as a nut for the supplied screws.
4. A lways provide water protection, if not supplied in the vehicle. We suggest
using a rain shield or equivalent. If in doubt, please contact your
Phoenix Gold Dealer.
SPECIFICATIONS:
Due to continual product improvement, all specifications subject to change without notice.
RMS Power Handling (watts)
Peak Power Handling (watts)
Impedance (ohms)
Cut Out Dimension (mm) / in.
Mounting Depth (mm) / in.
© 2013 Phoenix Gold • www.phoenixgold.com
All manuals and user guides at all-guides.com
Figure 1
Mounting the speaker in a factory location.
SX5CX
60W
120W
4
(118) 4.5
(61) 2.4
SPEAKER INSTALLATION WITHOUT GRILL
Phoenix Gold has provided a foam mounting gasket. When installing your new
component speakers in a factory location make sure to use the foam mounting
gasket as shown in figure 1. For reverse mounted speakers place the foam
gasket in front of the speaker. This will ensure an air tight seal for your SX
speakers.
For more custom applications, or cases where the factory grill will not be used,
a high excursion protective grill has been provided. When installing your new
component speakers with the provided SX grill use figure 2. Make sure to use
the rubber gasket to get an air tight seal.
SX57CX
SX6CX
75W
75W
150W
150W
4
4
(129 x 183) 7.2 x 5
(131) 4.9
(65) 2.6
(65) 2.55
Coaxial Speaker Owner's Manual
Figure 2
Mounting the speaker in a custom application.
SX65CX
SX69CX
75W
90W
150W
180W
4
4
(145) 5.6
(154 x 222) 8.6 x 6.1
(73) 2.9
(83) 3.3
Publicité
