Valor LEGEND G3.5 Instructions D'installation page 2

Installation
1. Identify the left and right panels using the image
below.
2. Identify the top and bottom of the left panel. The
notch in the rear fl ange of the panel is at the top.
The space between the rear fl ange and the edge of
the panel is wider at the top than at the bottom of
the panel as shown below.
Left door panel
Front view Rear view
3. Insert the top pin of the left panel in the hole at
the top of the left shroud already installed on the
appliance.
4. Lift the panel as far as possible and insert the
bottom pin in the hole at the bottom of the shroud.
The panel should rotate freely.
5. Install the right panel the same way.
2
6. Hook the barrier screen to the back of the front.
TOP of door:
this space is
wider
TOP of door:
notch in the
rear flange
BOTTOM of door:
this space is
narrower
7. Hook the front trim with the barrier screen to the
Orient the screen so its tabs are on the back.
Note: The barrier screen, when hooked to the
trim, protrudes slightly in front
of the trim.
Rear View
appliance's shrouds.
Screen tabs at
the back