Krüger & Matz KM0243FHD-S Mode D'emploi page 17

Owner's manual
A
B
Warning:
Be sure to follow the instructions for installation, if the base is not installed correctly,
it may result in the TV falling over. To remove the stand, perform the steps in reverse
order, the base can not adjust the angle. During the installation process, be careful
to avoid damage to the TV and your hand caught and ground to the bottom of the
TV.
Mounting on a wall
IMPORTANT This operation requires two people!
To ensure a safe installation, comply with the following safety instructions:
• Disconnect from power supply before mounting.
• Check that the wall can support the weight of the TV set and wall mount assembly.
• Follow the mounting instructions provided with the wall mount.
• The TV set must be installed on a vertical wall.
• Make sure to use only screws suitable for the material of the wall.
• Make sure that the TV set cables are placed in such a way that there is no danger
of tripping over them.
• Mounting the TV set on the wall should be performed only by professionals.
Step 1
Locate the 2 pcs of bottom
bracket into the gap in the
bottom of the TV, and check
that it is securely held in place
as in illustration A) below.
Step 2
Lock the 2 pcs screws in the
designated location
illustration B) below. Check
each screw is firmly tightened.
as in
17