Télécharger Imprimer la page

Team International TEAM FP 20 Mode D'emploi page 6

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 7
All manuals and user guides at all-guides.com
Fax +32 2 359 95 50
IMPORTANT INFORMATION
This appliance is not for professional use. You should follow the requested breaks. Failure to
follow this instruction carefully may result in damage to the motor. Please refer to the rating
label for the maximum continuous usage time (KB xx min where xx is the allowed maximum
usage time). The breaks should last at least 10 minutes.
ASSEMBLY & USE
Place the juice container on the shaft protruding from the motor block.
Therefore rotate it from a quarter clockwise until it stops.
Warning, your appliance is delivered with two different-sized cones (a small one and a big
one, which you can use indifferently according to the size of the fruit) that are fit into one
another. Should you wish to use the small cone, you have to remove the big one. To do so,
take the cone in one hand and turn it over to see the bottom of the sieve. Then press
gently the big cone on both lugs and separate it from the sieve.
To put the big cone back in place, do it the other way round.
Then fit the sieve and the cone over the shaft inside the juice container.
Cut the citrus fruit in half, cutting across sections. Place the inner side of the fruit on the
cone.
Simply push down on the extractor cone with the fruit to start the juicing action
automatically.
If the rotation reverses itself, this means that the pressure on the cone is too hard and or
the fruit is too hard (lightly release the pressure to check if the rotation becomes normal
again or stop the action), or the juice has been completely extracted and you have to
stop. When you stop pressing on the cone, the rotation stops automatically.
To serve the extracted fruit juice, take the container by the handle and turn it from a
quarter anticlockwise and remove the cone and the sieve from the container. Only the
fruit juice remains in the container because the pulp and the pips will get in the sieve.
Your appliance is delivered with a lid that you will place on the sieve after cleaning as a
hygienic measure.
After cleaning you can also roll the cord around the base in the cord storage.
CARE & CLEANING
Disassemble the parts (container, sieve, cone) in the way indicated before.
Clean the accessories of the appliance in warm soapy water and rinse them with clear
water. Do not put the accessories in the dishwasher.
Never put the motor block in the dishwasher. To clean the motor housing, wipe with a
damp cloth, only when necessary.
PROTECTION OF THE ENVIRONMENT – DIRECTIVE 2002/96/EC
In order to preserve our environment and protect human health, the waste electrical and
electronic equipment should be disposed of in accordance with specific rules with the
implication of both suppliers and users. For this reason, as indicated by the symbol
rating label or on the packaging, your appliance should not be disposed of as unsorted
municipal waste. The user has the right to bring it to a municipal collection point performing
waste recovery by means of reuse, recycling or use for other applications in accordance with
the directive.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
6
Assembly page 6/24
on the
TEAM FP 20 - 091202

Publicité

loading