Taurus TC-350 Mode D'emploi page 8

- Keep the working area clean and well lit. Clutte-
red and dark areas invite accidents.
- -The appliance should be used and kept over a
flat and stable surface.
- Do not use the appliance if the cable or plug is
damaged.
- If any of the appliance casings breaks, immedia-
tely disconnect the appliance from the mains to
prevent the possibility of an electric shock.
- Do not use the appliance if it has fallen on the
floor, if there are visible signs of damage or if it
has a leak.
- Never use the electric wire to lift up, carry or
unplug the appliance.
- Ensure that the electric cable does not get
trapped or tangled.
- Check the condition of the electrical connection
cable. Damaged or tangled cables increase the
risk of electric shock.
- This appliance is not suitable for outdoor use.
- The power cord must be regularly examined for
signs of damage and if damaged, the appliance
must not be used.
- Do not touch the plug with wet hands.
- Take the necessary measures to avoid starting
the appliance involuntarily.
USE AND CARE:
- Fully unroll the appliance's power cable before
each use.
- Do not use the appliance if its accessories are
not properly fitted.
- Do not use the appliance if the on/off switch
does not work.
- Do not move the appliance while in use.
- Do not use the appliance if it is tipped up and do
not turn it over.
- Do not turn the appliance over while it is in use
or connected to the mains.
- Respect the MAX level indicator (Fig. 1)
- This appliance is for household use only, not
professional or industrial use.
- This appliance should be stored out of reach of
children and/or the disabled.
- Any misuse or failure to follow the instruc-
tions for use renders the guarantee and the
manufacturer's liability null and void.
- Perform cycles of no more than 1.5 minutes.
Always respecting periods of rest between
cycles of at least 15 seconds. Under no circum-
stances should the appliance be operated for
more time than necessary.
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that all the product's packaging has
been removed.
- Before using the product for the first time, clean
the parts that will come into contact with food in
the manner described in the cleaning section.
PULP QUANTITY REGULATOR
- This appliance has a system for regulating the
quantity of pulp filtered.
- The quantity of pulp can be regulated by turning
the jar while holding the motor support
- For maximum filtering, turn the jar anticlockwise
until it stops. Fig.2A
- For minimum filtering, turn the jar clockwise until
it stops. Fig.2B
USE:
- Unroll the cable completely before plugging it in.
- Fit the jar (C) onto the motor body (A) until it
engages, place the strainer (D) over the jar
and to finish, fit the cone (E) into the strainer by
pressing it until it engages
- Connect the appliance to the mains.
- Cut the citrus fruit/s to be squeezed in half.
- Turn on the appliance by pushing down on the
piece of citrus fruit, once it has been placed on
the juicing cone.
- To stop the appliance, simply stop applying
pressure to the cone.
- Remove the cone and strainer assembly in
order to empty the jar.
- Empty the jug of juice, tipping its contents into
whatever table service receptacle you like.
- Note: If you process large quantities of fruit,
you will need to clean the filter and remove the
residual pulp on a regular basis.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Unplug the appliance to the mains.
- Put the cable back in the cable housing.
- Clean the appliance
CORD HOUSING
- This appliance has a cable compartment situa-
ted on its underside (Fig. 3)
CLEANING
- Disconnect the appliance from the mains and let
it cool before undertaking any cleaning task.