LITELINE LC-DVR-CV96W1 Mode D'emploi page 4

Functions – In:
All manuals and user guides at all-guides.com
+ Positive terminal for Power input of the Adapter and LED
- Negative terminal (Ground) for Power input
Functions – Out:
Vcc Positive driving for all LEDs. Connect to the anode of LED
WW Negative driving for Warm White LED
R Negative driving for Red LED
G Negative driving for Green LED
B Negative driving for Blue LED
CW Negative driving for Cool White LED
What you need
Pliers
Installation
1. Use wire connectors (not included) to connect the driver (not included) to the input
side of the OnCloud Adapter. Ensure to follow the above input ratings.
2. Use wire connectors (not included) to connect the constant voltage lighting fi xture
to the output side of the OnCloud Adapter. Ensure to follow the above output
ratings for 1/2/5 channel applications.
3. Power ON the driver to allow the OnCloud Adapter to receive power.
4. Proceed to WiZ app setup – Refer to "WiZ Quick Setup Guide".
Notes:
1. If installing the OnCloud Adapter in a metal enclosure, keep an air gap between the metal plate and
the OnCloud Adapter of at least 5mm. Also, the wireless antenna is on the black/red input wire side,
so consider exposing outside of the metal enclosure to improve signal strength.
2. The OnCloud Adapter is a low voltage product and, in most regions, does not require to be mounted
in an enclosure. Avoid metal enclosures to increase wireless signal propagation. Always install in
accordance with local code.
Wire Stripper Wire Connectors Non-dimming
Driver