Philips AZ1120 Mode D'emploi page 9

RECORDING
GENERAL INFORMATION ON RECORDING
• Recording is permissible insofar as copyright or other rights of
third parties are not infringed.
• This deck is not suited for recording on CHROME (IEC II) or
METAL (IEC IV) type cassettes. For recording, use only
NORMAL type cassettes (IEC I) on which the tabs have not
been broken.
• The best recording level is set automatically. Altering the
VOLUME and DBB controls will not affect the recording in
progress.
• At the very beginning and end of the tape, no recording will
take place during the 7 seconds, when the leader tape passes
the recorder heads.
• To protect a tape from accidental erasure, have the tape in
front of you and break out the left tab.
Recording on this side is no longer possible. To record over this
side again, cover the tabs with a piece of adhesive tape.
Synchro Start CD recording
1. Set the source selector to CD.
2. Insert a CD and if desired, programme track numbers.
3. Press STOP•OPEN 9 / to open the cassette holder. Insert a
blank tape.
4. Press the cassette holder shut.
5. Press RECORD 0 to start recording.
– Playing of the CD programme starts automatically from the
beginning of the programme.
It is not necessary to start the CD player separately.
6. For brief interruptions press PAUSE ;. To resume recording,
press PAUSE ; again.
7. To stop recording, press both STOP•OPEN 9 /.
To select and record a particular passage
During CD playback, press and hold down the SEARCH buttons
∞ or § to find your passage.
• Press PLAY•PAUSE 2; to put the CD player on pause at the
selected passage.
– Recording will begin from this exact point in the track when
you press RECORD 0.
Recording from the radio
1. Set the source selector to FM/MW.
2. Tune to the desired radio station using
(see RADIO RECEPTION).
3. Press STOP•OPEN 9 / to open the cassettte holder
Insert a blank tape
4. Press the cassette holder shut.
All manuals and user guides at all-guides.com
MAINTENANCE
9