Publicité
Liens rapides
Publicité
Sommaire des Matières pour Automated Production TC4-4M
- Page 1 Mist Control TC4-4M USER'S MANUAL TC4-4M M 890-00149 rev. 03 REV. 00...
- Page 2 TABLE OF CONTENTS TC4-4M.rev.03...
- Page 3 PRECAUTIONS FOR CUSTOMER USE Enter the serial number located on the side of the controller below for future reference. TC4-4M Model number: Serial number: TC4-4M.rev.03...
- Page 4 FEATURES TC4-4M.rev.03...
- Page 5 LOCATION OF THE CONTROLS TC4-4M T / MAN. / AVG. T T / MAN. STAGE A STAGE A STAGE B STAGE B T / MAN. / DIFF. T / MAN. STAGE A STAGE A STAGE B STAGE B TC4-4M.rev.03...
- Page 6 TC4-4M TC4-4M.rev.03...
- Page 7 TC4-4M Internal Switches NOTE : TC4-4M.rev.03...
- Page 8 PARAMETER RANGES i t n NOTES : TC4-4M.rev.03...
- Page 9 INSTALLATION OUNTING INSTRUCTIONS ONNECTIONS ALL WIRING MUST BE DONE BY AN AUTHORIZED ELECTRI- CIAN AND MUST COMPLY WITH APPLICABLE CODES, LAWS AND REGULATIONS. BE SURE POWER IS OFF BEFORE DOING ANY WIRING TO AVOID ELECTRICAL SHOCKS AND EQUIPMENT DAMAGE. TC4-4M.rev.03...
- Page 10 TC4-4M EMPERATURE PROBES Œ CAUTION: CAUTION: Ž TC4-4M.rev.03...
- Page 11 TC4-4M LASHING DISPLAY OCKING THE PARAMETER SETTINGS TC4-4M.rev.03...
- Page 12 TEMPERATURE SETTINGS IEWING TEMPERATURES Œ Ž TC4-4M.rev.03...
- Page 13 TC4-4M TC4-4M.rev.03...
- Page 14 TC4-4M CAUTION TC4-4M.rev.03...
- Page 15 TIMER OPERATION TIME ON STAGE A MIST ON MIST OFF TIME OFF STAGE A TC4-4M.rev.03...
- Page 16 TC4-4M TEMPERATURE FALLS 92 F TIME ON STAGE B 90 F TIME OFF TIME ON 90 F TEMPERATURE SETTING B STAGE A TIME OFF TIME ON 82 F STAGE A TIME OFF 80 F TEMPERATURE SETTING A MIST OFF TEMPERATURE RISES...
- Page 17 1 2 3 4 5 6 1 2 3 4 5 6 1 2 3 4 5 6 1 2 3 4 5 6 1 2 3 4 5 6 1 2 3 4 5 6 1 2 3 4 5 6 TC4-4M.rev.03...
- Page 18 TC4-4M 1 2 3 4 5 1 2 3 4 5 1 2 3 4 5 1 2 3 4 5 1 2 3 4 5 1 2 3 4 5 1 2 3 4 5 1 2 3 4 5...
- Page 19 TC4-4M 1 2 3 4 5 1 2 3 4 5 1 2 3 4 5 1 2 3 4 5 1 2 3 4 5 1 2 3 4 5 1 2 3 4 5 1 2 3 4 5...
- Page 20 TC4-4M Ž TC4-4M.rev.03...
- Page 21 TC4-4M TC4-4M.rev.03...
- Page 22 There is electrical Do not run probe cables next to temperature. noise near an ex- other power cables. When tended probe cable. crossing other power cables, cross at 90 TC4-4M.rev.03...
- Page 23 TC4-4M Replace the fuse. The mist The fuse is open. units are not operating. Make sure the cable is firmly The display board plugged in with the tabs in place. interconnect cable is not plugged into the power supply board properly.
- Page 24 TECHNICAL SPECIFICATIONS TC4-4M.rev.03...
- Page 25 NOTES...
- Page 26 NOTES...