Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
HOLLYWOOD RACKS
Assembly and Installation instructions Model # HR520
WARNING! THIS PRODUCT IS NOT TO BE USED ON ANY TRAILER
PLEASE FOLLOW THESE IMPORTANT POINTS:
DRIVE SLOWLY WHEN USING THE RACK ON BUMPY OR DIRT ROADS.
CHECK THE RACK, BIKES AND STRAPS REGULARLY DURING USE.
IF YOU HAVE ANY QUESTIONS OR INSTALLATION PROBLEMS, PLEASE SEE YOUR
RETAILER OR CONTACT US AT 800 – 747- 4085.
Fig. 4:
Rubber strap: qty =15
Woven strap: qty = 5
(one attached to rack)
All manuals and user guides at all-guides.com
Road Runner 5 Bike Hitch Rack
Fig. 2
Qty = 2 each
Fig. 1
Fig. 5
1
2" class 3 hitch req'd
Fig. 6
Publicité
Manuels Connexes pour Hollywood Racks Road Runner 5
Sommaire des Matières pour Hollywood Racks Road Runner 5
- Page 1 All manuals and user guides at all-guides.com Road Runner 5 Bike Hitch Rack HOLLYWOOD RACKS Assembly and Installation instructions Model # HR520 2” class 3 hitch req’d WARNING! THIS PRODUCT IS NOT TO BE USED ON ANY TRAILER PLEASE FOLLOW THESE IMPORTANT POINTS: ...
- Page 2 All manuals and user guides at all-guides.com After opening the box, you should have the following parts: - Upright beam assembly (Fig 1) with wheel brace installed - Two Support Arms (see Fig. 1) - Parts bag including ½” diameter bolt, washers and nut, lynch pin and clip (Fig.
- Page 3 All manuals and user guides at all-guides.com INSTALLING BIKES ON THE RACK: 7. Back off the knob on the rack’s support arms, pull out the support arms and rotate them into the horizontal position. The arms should fit into the welded steel channels. Retighten the knobs securely. Rotate lower brace to its horizontal position.
- Page 4 (at its option) a defective part or the complete rack without charge for labor or parts. Hollywood Racks may elect (at its option) to issue a refund equal to the purchase price paid for the product.
- Page 5 Boulonnerie pour bras de supports, mollettes et pièces platique rond et carré Fig. 3. - Sachet de pièces contenant. Sangle d’attache (caoutchouc et nylon) Fig. 4. Note: Road Runner 5 possède 15 sangles en caoutchouc et 5 sangles en nylon. - Tube pour l’attelage remorque avec le systeme anti-jeu at levier Fig. 5.
- Page 6 All manuals and user guides at all-guides.com Installer les velos sur le porte-vélo. 1. Deserrer les mollettes de chaque côté des bras de supports, et faire pivoter les bras de supports dans une position horizontale ou d’utilisation dans les pièces soudées sur chaque côté. Reserrer les mollettes fermements. Dévisser la molette de la barre inferieure (Fig 6) et faire pivoter en position horizontale.