Télécharger Imprimer la page

JVC KS-RC108 OE Instructions De Montage page 2

Indication de montage de l'adaptation de commande au volant renault avec mini iso

Publicité

Possible remote controls:
Geeignete Lenkradfernbedienungen:
Commande au volant compatible:
Kangoo, Clio, Megane, Scenic
Installation:
Einbauanleitung:
Procédure d´installation:
1.
Remove and disconnect the car receiver previously built in your car.
Das Originalradio ausbauen.
Démontez la radio d'origine.
2.
Connect the mini ISO plug from KS-RC108 to the car harness.
Mini ISO Stecker vom KS-RC108 auf das Gegenstück im Radioschacht stecken.
Liez la fiche mini ISO de la KS-RC108 au pendant dans l'ouverture d'emplacement de la radio.
3.
Put the mono plug from KS-RC108 into the JVC car receiver.
Den Klinkenstecker des KS-RC108 mit der Kupplung am JVC Radio verbinden.
Liez la fiche à jack du KS-RC108 à la radio JVC.
4.
Connect the red wire from KS-RC108 to Ignition (KL.15), and the ISO connector to the JVC car
receiver.
Einzelne rote Leitung des KS-RC108 mit der Zündung (Klemme 15) verbinden, ISO Stecker in
das JVC Radio stecken.
Liez le câble rouge de la KS-RC108 à l'allumage (borne 15),
branchez la fiche ISO dans la radio JVC.
5.
Switch on the JVC car receiver and check the steering wheel control.
JVC Radio einschalten, Steuerfunktionen überprüfen.
Allumez la radio JVC, vérifiez les fonctions de contrôle.
6.
Put back the JVC car receiver into the dashboard or its dedicated location.
JVC Radio einbauen.
Montez la radio JVC.
LVT1098-009A
Downloaded from:
https://www.usersmanualguide.com/
Laguna, Laguna II
2

Publicité

loading