Isotek EVO3 GENESIS ONE Instructions D'installation

EVO3 GENESIS ONE
INSTALLATION INSTRUCTIONS

SAFETY FIRST
PLEASE READ THE FOLLOWING INSTRUCTIONS BEFORE INSTALLATION
DO NOT expose this product to dripping or splashing and no objects filled with liquids, such as vases,
shall be placed on the apparatus. If liquid enters the chassis immediately turn off and unplug from the wall socket.
DO NOT impede ventilation by covering the ventilation openings with items, such as newspapers,
table-cloths, curtains, etc.;
DO NOT expose this product to naked flame sources, such as lighted candles, these should not be placed
on the apparatus;
MAKE SURE that this appliance (CLASS 1) is connected to a mains outlet socket with protective earth.
PLEASE NOTE that the mains plug is used as the disconnect device and must remain readily operable.
OUTPUT SOCKETS
ADDITIONAL INFORMATION ON FUSING AND RATINGS
A
The output socket marked 'A' is designed for use with source components, CD player, pre amplifiers, music servers,
digital to analogue converters, loads of typically no greater than 100W total power consumption.
The output socket marked 'B' is designed to connect additional Genesis One units together in a daisy chain
B
configuration so that only one master input power cable is required to power the first unit. This output socket is
rated at 2300W.
A
Power on/off switch
B
SERVICE & REPAIR
NO USER SERVICEABLE PARTS INSIDE
Should the unit fail, or cease to function, or function in a manner which seems unusual, please immediately turn off
and unplug from the mains supply.
Send an email to: support@isoteksystems.com
All manuals and user guides at all-guides.com
IEC input