i-tec Aduance Serie Manuel De L'utilisateur page 5

A: Charging the power bank:
1. Check charging / capacity status of power bank (see below – point C, D) and charge it if it is
needed. Please use USB cable supplied in the package and use USB micro port to connect the
power bank and a PC/NB USB port (USB 2.0 / 3.0) or 230 V USB charger (e.g. i-tec Dual USB
Power Charger).
2. The state of charge is indicated by LED lights (point D)．
Note: During charging the power bank is not possible to charge connected USB devices.
B: Charging the other devices:
1. For charging connected devices use USB 2.0 output port of power bank (USB type A). Please use
USB cable supplied in the package (or USB cable supplied to charged device) and connect the
device. For iPhone, iPad, iPod use the original USB cable.
2. Press ON/OFF button, it will begin charging within 5 seconds. Check charging on the connected
device.
3. LED on the power bank lights up during charging the connected device; this indication during
charging can be turned on / off using the ON / OFF button (charging continues to full charge).
C: Power indicating:
1. Press ON/OFF button, LED lights shows charging status (according the capacity) and will be go
off after 5 sec, if the charging device is not connected.
2. If the power indicator is flashing, it is short of power. Charge power bank.
3. After pressing ON/OFF button no lights are on, the capacity is low (it is necessary to charge power
bank) or broken device (please contact our service department).
D: LED charge status display (for power bank):
Four LEDs all on:
Only three LEDs on:
Only two LEDs on:
Only one LED on:
PACKAGE CONTENT
i-tec power bank 3400 mAh
USB cable, connector type A-Micro USB (33.5 cm)
User's guide
All manuals and user guides at all-guides.com
100%
≥75%
≥50%
≥25%
Quick Start
EN
03