Checking For Leaks - Pegasus 873-9004 Guide D'utilisation Et D'entretien

Installation (continued)
9

Checking for leaks

□
Place the handle (F) on the valve body (D)
inverter and turn the handle to the full on mixed
position.
□
When the valve is turned on, water normally
ows through the tub spout (I). To activate the
shower, turn the valve on and pull the knob (1)
up. Hold the knob (1) until the water ows
continiously from the shower arm (B). Check for
leaks.
□
Shut off the water at the faucet and supply lines.
Remove the handle (F).
B
F
I
D
UP
FOR
1
SHOWER
10
Installing the escutcheon
and handle
□
Install the escutcheon (E) onto the valve body
(D) using the escutcheon screws (AA).
□
Place the handle (F) onto the valve body (D) and
tighten the set screw (G) with the Hex wrench
(Hex: 2.5 mm) provided.
AA
F
G
9
Please contact 1-877-580-5682 for further assistance.
E
WWW.HOMEDEPOT.COM/PEGASUS
D