Uline H-10306 Instructions De Montage page 3

STORAGE CABINET
Open H-10295 carton first to assemble storage
cabinet in steps 1-11.
NOTE: Assemble unit on a smooth, non-marring
surface to prevent scratching. Check that all
parts are included.
IMPORTANT! Turn cam lock 1/4 to the right to
lock.
IMPORTANT: Function of Cam Lock
Make sure the arrow is pointing upward
before inserting into the panel's hole.
IMPORTANT! Cam lock pins must be tightened
once inserted into panel. To tighten cam lock
pins, grasp lower part of cam lock pin and
tighten using a Phillips screwdriver.
TIGHTENING OF CAM LOCK PINS
NOTE: Use Phillips screwdriver to tighten cam
locks, cam lock pins and screws.
NOTE: Cam lock caps (I) can be applied once
cam locks are tightened for a finished look.
PAGE 3 OF 24
1/4 Right Turn
for Locking
Hold while
tightening
ASSEMBLY
1. Install one cam lock pin (D) in bottom panel (4).
Insert one cam lock (E) into corresponding hole
in skirt panel (6). Fit bottom panel and skirt panel
together and tighten cam lock. (See Figure 1)
Figure 1
2. Install two cam lock pins (D) and two dowels (G)
in back panel (5). Insert two cam locks (E) into
corresponding holes in bottom panel (4). Fit back
panel and bottom panel together and tighten cam
locks. (See Figure 2)
Figure 2
5
5
6
E
D
D
D
4
4
D
G
D
4
E
4
4
E
5
0223 IH-10306