Publicité
Les langues disponibles
Les langues disponibles
Installation
1
Installing the faucet assembly
CAUTION: Always shut off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old
faucet.
□
Clean the mounting surface.
□
Remove the preassembled lock nut (H) and
washers (G) from the new faucet (A).
□
Place the faucet (A) through the mounting
holes in the sink.
□
Secure the faucet (A) to the sink using the
washers (G) and lock nut (H) provided.
NOTE: Ensure that the hole for the lift rod faces toward
the rear of the sink during installation. When you insert the
lift rod (S), the lift rod (S) can go through the faucet (A) and
down into the slot of the washers (G).
A
2
1
H
A
G
H
2
Installing the faucet handles
NOTE: The hot water valve is identi ed with a label.
□
Remove the preassembled nuts (E) and washers
(D) from the hot and cold faucet handles (B and C).
□
Loosen the screws (F) on the nuts (E) until the
ends of the screws (F) are ush with the face of
the nuts (E).
□
Insert the hot faucet handle (B) to the left of the
spout and cold faucet handle (C) to the right of
the spout.
□
Attach the faucet handles (B and C) underneath
the sink using the washers (D) and nuts (E).
Securely tighten the screws (F) on the nuts (E).
E
B
D
3
E
F
4
F
2
C
2
D
3
E
F
E
F
Publicité
