Casselin CAN400L Mode D'emploi page 11

Operation
Temperature Setting and Control (Dixell)

The front panel of the thermostat display:
How to see the set point
• Push and immediately release the SET key, the set point will be showed;
• Push and immediately release the SET key or wait about 15s to return to normal visualisation.
How to change the set point
• Push the SET key for more than 2 seconds to change the set point value;
• The value of the set point will be displayed and the "°C" starts blinking;
• To change the set value push the „
• To memorise the new set point value push the SET key again or wait 15s.
Automatic defrost
• The appliance will automatically run defrost cycles.
Note: The cycle starts from the time the appliance is initially powered up.
Manual Defrost:
• Press and hold the DEFROST
• The defrost cycle will start immediately and the Defrost LED illuminates.
Note: Starting a manual defrost also resets the automatic defrost timer.
How to turn ON / OFF the light

Press and release the
Note: Light logo is present and active only for model with glass door.
GB
" (up) or " " (down) arrows within 15s.
button for 5 seconds.
key, the light will switch ON or OFF.
9
1. Defrost indicator
2. Compressor operation indicator
3. SET key
4. Temperature modification keys
5. Defrost button
P2M058STD-Ver1.1