LATICRETE STRATA HEAT Guide De Configuration page 2

STRATA_HEAT Programmable Thermostat
™
SETTING UP YOUR THERMOSTAT
1. Language – Set your language preference
2. Heater Type
Electric floor
The power settings have to be entered. Voltage is defaulted to 120V
and the power is the total wattage of the heaters which the
STRATA_HEAT Program Thermostat is controlling. The wattage ratings of
the heaters can be found in the heater manual or online at
www.laticrete.com.
3. Set time – Set the current time
4. Set date – Set the current date
5. Set daylight savings – Set Europe, N.America, Australia or
switch off
6. Temperature format – Set the format as degrees Celsius or
Fahrenheit
7. Home screen style – Set your home screen style
8. Background image – Set your background style
9. Display brightness – Set the display and standby brightness
10. Audio feedback – To turn the touch sounds when making a
selection ON/OFF
11. Heating target – Control the heating via air or floor sensor
12. Heating limits – Delicate floor coverings such as vinyl, carpet
and laminate must be limited to 81°F (27°C). Tile floors can be set to
a maximum of 104°F (40°C)
13. Cost setting – Select the rate you are on with your energy
provider and enter cost per kWh
14. Program setting – Select a preset program, set a fixed
temperature or set your own custom program
15. Setback temperature – The setback temperature is the
temperature you set for periods where you would like a lower
temperature or no heating
NOTE: When the reset has been pressed, the time for reset will need
2 ~ 5 seconds.
2
Easy Setup Guide