KING KP130 Manuel D'instructions Et D'utilisation Du Propriétaire

Masquer les pouces

page de 48

/ 48
Signets

Liens rapides

Télécharger ce manuel

Owner's Instruction and Operation Manual

Model Number:

KP130

Report Number: F20-570

Certified to ASTM E1509-12 (2017)

and ULC-S627-00-REV1

Mobile Home Approved

* All Pictures In This Manual Are For Illustrative Purposes Only. Actual Product May Vary.

Save These Instructions In A Safe Place For Future Reference.

SAFETY NOTICE: If this heater is not properly installed, a house fire may result. For

your safety, follow the installation instructions. Never use make-shift compromises

during the installation of this heater. Contact local building or fire officials about

permits, restrictions and installation requirements in your area. NEVER OPERATE

THIS PRODUCT WHILE UNATTENDED.

CAUTION! Please read this entire manual before you install or use your new room

heater. Failure to follow instructions may result in property damage, bodily injury, or

even death. Improper Installation Will Void Your Warranty!

U.S. Environmental Protection Agency

Certified to comply with 2020 particulate

emissions standards.

THIS MANUAL IS SUBJECT TO CHANGE WITHOUT NOTICE.

CALIFORNIA PROPOSITION 65 WARNING:

This product can expose you to chemicals including carbon

monoxide, which is known to the State of California to cause

cancer, birth defects, and/or other reproductive harm. For

more information, go to

853143B-0403K

www.P65warnings.ca.gov

Ph. 800-750-2723

Sommaire des Matières pour KING KP130

Page 1 Owner’s Instruction and Operation Manual Model Number: KP130 Report Number: F20-570 Certified to ASTM E1509-12 (2017) and ULC-S627-00-REV1 Mobile Home Approved * All Pictures In This Manual Are For Illustrative Purposes Only. Actual Product May Vary. 853143B-0403K Save These Instructions In A Safe Place For Future Reference.
Page 2 Your pellet stove has been safety tested and listed to ASTM E1509-12 (2017) and ULC-S627-00. This manual describes the installation and operation of the King, KP130 pellet stove. This heater meets the 2020 U.S. Environmental Protection Agency’s crib wood emission limits for wood-heaters sold after May 15, 2020. Under specific EPA test conditions burning wood pellet fuel this heater has been shown to deliver heat at a rate of 8,932 to 25,701 Btu/hr.
Page 3 INSTALLATION CHECKLIST Your Wood Stove should be installed by a qualified installer only. An NFI qualified Installer can be found at www. nficertified.org/public/find-an-nfi-pro/ CUSTOMER SERVICE 1-800-750-2723 ext 5050 Text to 423-301-5624 Email to: Customerservice@usstove.com COMMISSIONING CHECKLIST This checklist is to be completed in full by the qualified person who installs this unit. Keep this page for future reference. Failure to install and commission according to the manufacturer’s instructions and complete this checklist will invalidate the warranty.
Page 4 INSTALLATION CAUTION: SAFETY NOTICE BURNING FUEL CREATES CARBON MONOXIDE • IF THIS STOVE IS NOT PROPERLY INSTALLED, AND CAN BE HAZARDOUS TO YOUR HEALTH IF A HOUSE FIRE MAY RESULT. TO REDUCE THE NOT PROPERLY VENTED. RISK OF FIRE, FOLLOW THE INSTALLATION INSTRUCTIONS.
Page 5 INSTALLATION INSTALLATION OPTIONS accordance with the clearances given in this manual. NOTE: The distance on the side of your pellet stove may Freestanding Unit - supported by pedestal/legs and need to be greater than the minimum required clearance placed on a non-combustible floor surface in compliance for suitable access to the control panel.
Page 6 INSTALLATION OUTSIDE AIR SUPPLY • The heater must be electrically grounded to the steel (OPTIONAL, UNLESS chassis of the mobile home with 8 GA copper wire INSTALLING IN A MOBILE HOME) using a serrated or star washer to penetrate paint or Depending on your location and home construction, protective coating to ensure grounding.
Page 7 INSTALLATION PELLET VENT TERMINATION vent must not exceed 4-feet. This could cause back pressure. Use no more than 180 degrees of elbows (two Do not terminate the vent in an enclosed or semi-enclosed 90-degree elbows, or two 45-degree and one 90-degree area, such as;...
Page 8 INSTALLATION HORIZONTAL EXHAUST VENT F. Minimum 3-foot (0.91m) clearance from an forced air intake of any appliance. INSTALLATION Locate your pellet stove in a location which meets the G. Minimum 2-foot (0.61m) clearance below eves or requirements of this manual, but in an area where it overhang.
Page 9 INSTALLATION THROUGH THE WALL INSTALLATION from the outside wall and a clean out tee should be placed on the pipe with a 90-degree turn away from the (RECOMMENDED INSTALLATION) house. At this point, a 3ft (0.91m) (minimum) section of pipe should be added with a horizontal cap, which would complete the installation.
Page 10 OPERATION INSTRUCTIONS NEVER OPERATE THIS PRODUCT WHILE UNATTENDED HOW YOUR STOVE WORKS will be consumed and the fire will go out. Matching the amount of air required for proper combustion to the fuel rate is the primary objective in effectively burning pellets 4 Digit Display of various brands and qualities in your stove.
Page 11 OPERATION INSTRUCTIONS • During start-up ignition must occur within 12 minutes this speed can be manually operated by pressing the or the stove will error out and show E3. “Draft Fan” arrows up or down. “Draft Fan” when pressed, the display will show “Df-A”, which is automatic. Press •...
Page 12 OPERATION INSTRUCTIONS THERMOSTAT HOOK-UP The Jumper Must Be Removed First 1. Put female terminals on the lead wires to your low voltage thermostat. 2. Plug one thermostat lead onto each of the terminal posts on the circuit board. IMPORTANT NOTE: The purpose of the T’Stat is make stove...
Page 13 OPERATION INSTRUCTIONS standard (minimum of 40 lbs density per cubic ft, 1/4” to WARNING: 5/16” diameter, length no greater than 1.5”, not less than • DO NOT USE CHEMICALS OR FLUIDS TO START 8,200 BTU/lb, moisture under 8% by weight, ash under THE FIRE - NEVER USE GASOLINE, GASOLINE- 1% by weight, and salt under 300 parts per million).
Page 14 OPERATION INSTRUCTIONS PRE-START-UP CHECK down. If the stove shuts down push the “On/Off” button to re-start your stove. The stove will have to fully shut Remove burn pot, making sure it is clean and none of the down and turn off before you will be able to restart the air holes are plugged.
Page 15 OPERATION INSTRUCTIONS SHUTDOWN PROCEDURE be done at least once per month or more frequently if large amounts of ash are noticed while cleaning or if the stove does not seem to be burning properly. WARNING: NEVER SHUT DOWN THIS UNIT BY UNPLUGGING Over time ash or dust may accumulate on the blades IT FROM THE POWER SOURCE.
Page 16 MAINTENANCE NEVER OPERATE THIS PRODUCT WHILE UNATTENDED type of chimney in use. A qualified chimney sweep can CAUTION: perform this service. It is also recommended that before • FAILURE TO CLEAN AND MAINTAIN THIS each heating season the entire system be professionally UNIT AS INDICATED CAN RESULT IN POOR inspected, cleaned and, if necessary, repaired.
Page 17 MAINTENANCE CHECK & CLEAN THE HOPPER 6. Never use substitute materials for the glass. Check the hopper periodically to determine if there is any DO NOT abuse the door glass by striking, slamming, or sawdust (fines) that is building up in the feed system or similar trauma.
Page 18 TROUBLESHOOTING GUIDE • Disconnect the power cord before performing any maintenance! NOTE: Turning the ON/OFF Switch to ”OFF” does not disconnect all power to the electrical components of the stove. • Never try to repair or replace any part of the stove unless instructions for doing so are given in this manual. All other work should be done by a trained technician.
Page 19 TROUBLESHOOTING GUIDE Error Code Error Description Possible Causes Inadequate ventilation. Room fan failure. Err1 The high limit temperature sensor has tripped. Exhaust Blockage. Electrical Open in wiring. Hopper Empty. Auger output failure or jam. Flame of fuel quality caused fire to burn too slowly or Err2 Stove ran out of fuel during normal operation.
Page 21 WIRING DIAGRAM BLACK GRAY Ensure the wires are connected to the bottom two prongs of the hopper switch as shown. CORRECT WRONG HOW TO ORDER REPAIR PARTS For Parts Assistance Call: 800-750-2723 Ext 5051 or Email: parts@usstove.com The information in this owner’s manual is specific to your unit. When ordering replacement parts the information in this manual will help to ensure the correct items are ordered.
Page 22 SERVICE RECORD It is recommended that your heating system is serviced regularly and that the appropriate Service Interval Record is completed. SERVICE PROVIDER Before completing the appropriate Service Record below, please ensure you have carried out the service as described in the manufacturer’s instructions.

KING KP130 Manuel D'instructions Et D'utilisation Du Propriétaire

Liens rapides

Manuels Connexes pour KING KP130

Sommaire des Matières pour KING KP130