Hanseatic SY-103D3-E3-C9-600 Manuel D'instructions page 35

Installation
2. Open glass cover, take out grease filter 1a.
3. Hold exhaust hood 1 up to wall in such a way that the clearance to the
cooker (at least 65 cm) is observed and the middle of exhaust hood and
the aid line align.
Alignment must be checked with spirit level.
4. Draw the two drill holes for mounting from the inside of the hood.
5. Remove the hood again.
6. Drill two holes in the wall with a diameter of ø 8 mm at the
marked spots.
7. Put two screw plugs 7 in the drill holes.
8. Engage two screws 8 into the wall.
9. Mount exhaust hood and tighten the two screws 8 on the
inside of extraction hood.
10. Slide exhaust hose on air vents of hood and fasten with a
hose clamp (not included in scope delivery), if you would
like to use hood in air extraction mode.
11. Assemble both chimney facings. Fix these using the external
metal plate and two screws 4x10mm. Make sure that the
internal chimney facing can move vertically.
12. Put the the chimney facing unit on the cover.
13. Hold the upper attachment bracket on the wall at the required height of the
chimney so that the centre of the bracket and vertical guide line for the cover
are flush. Mark two holes and drill them, insert the dowels (not supplied) and
install the attachment bracket on the wall.
14. Pull the upper chimney cover from the lower chimney cover upwards and
attach it to the attachment bracket using two screws 4x10mm and ix the
position with the internal metal plate 4x10mm.
15. Guide the mains cable in the chimney cover, so that it is not visible, to the
socket and connect the cover.
12
Preparation
1a
7
8