Napoleon IR3-1 Mode D'emploi page 2

6.2.3 TURNING "ON" THE APPLIANCE
A. Place the "ON/OFF" switch in the "ON" position by the receiver, refer to "INSTALLATION OVERVIEW"
for location.
B. Using the remote transmitter simultaneously press the large fl ame button
you hear a short beep, this confi rms the start of the appliance, you can then release both buttons. (The
ignition process has begun once continuous beeping has begun).
C. Wait several seconds for the appliance to ignite. After main ignition the remote will default to the
Daytime Temperature Mode
NOTE: Refer to "GENERAL REMOTE TRANSMITTER LAYOUT".
6.2.4 TURNING "OFF" THE APPLIANCE
A. Using the remote transmitter press the "OFF" button.
NOTE: To turn the appliance on after pressing the "OFF" button, you must wait 30 seconds. The
appliance will shut off if no change has occured to the flame height or if the appliance has not turned
on for a period of 5 days.
6.2.5 HAND HELD REMOTE TRANSMITTER OPERATIONS
A. Press the "Set" button to change modes.
B. The modes change in the following order:
NOTE: Refer to "GENERAL REMOTE TRANSMITTER LAYOUT".
MAN
• For fl ame height adjustment in Manual Mode
increase to the highest fl ame height. Double click the small fl ame button
lowest fl ame height. Press the large fl ame button
button
will switch the appliance to pilot mode. To turn the appliance off completely press the
"OFF" button.
• For Daytime Temperature Mode
ignited). The default temperature setting for this mode is 23°C / 74°F. (Daytime Temperature
mode is set by comparing the set temperature and room temperature, the fl ame height is then
adjusted automatically to achieve this Daytime Temperature setting.)
• For Nighttime Temperature Mode
ignited). (Nighttime Temperature mode is set by comparing the night time set temperature and
room temperature, the fl ame height is then adjusted automatically to achieve this Nighttime
Temperature setting.)
• Timer Mode
timer settings available (P1 and P2) allowing the appliance turn off and to turn on at specifi ed
times.
All manuals and user guides at all-guides.com
.
TEMP
TEMP TEMP
to decrease fl ame height. NOTE: Holding the small flame button for too long
TIMER
the appliance must be set to standby mode (pilot ignited). There are two
NOTE: The "TIMER DISPLAY" indicates the set temperature every 30 seconds.
TIMER MAN
MAN
double click the large fl ame button
to increase fl ame height or the small fl ame
TEMP
the appliance must be set to standby mode (pilot
TEMP
the appliance must be set to standby mode (pilot
and the OFF button until
to
to decrease to the
W415-1198 / 05.24.13
EN