MaxLite RS Serie Manuel D'instructions page 5

Operating Instructions
MaxLite RS Series
®
For Model #: RS2-8U65WCS
Remove ballast cover,ballast,
socket-bars and wiring
Figure 2
Installation Steps:
1.
2. Remove and discard the host fixture lamp(s). (Fig. 1)
Shut off power to existing fixture. Disconnect the black and the white power supply wire to existing ballast.
3.
4.
Remove ballast cover, ballast, sockets/bracket and wiring.
the center piece of the provided bracket to connect two 4ft pieces together. (Fig. 2)
For 8ft installations break off the two end pieces of the provided bracket and install onto fixture and use
5.
6.
Secure the retrofit kit with safety cables to the housing.
7.
Make electrical connections.
8. Install lens, be sure it snaps into place along the entire length of the fixture. (Fig. 3)
Install LED retrofit with quarter turn provided.
9. Electrically activate the fixture. (Fig. 4)
© Copyright 2022. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
Bracket Safety cable
Housing
Bracket Bracket
Figure 1
Figure 3
Figure 4
RS Series
Page: 5
REV: 12/20/22