Wagan Tech 2003-5 Guide D'utilisation page 5

Masquer les pouces Voir aussi pour 2003-5:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Smart AC
400W USB+
by Wagan Tech
Television Interference
Operating the power inverter can interfere with television reception on some
channels. If this situation occurs, the following steps may help to alleviate the
problem:
• Make sure that the chassis ground lug on the back of the power
inverter is solidly connected to the ground system of your vehicle.
• Do not operate high power loads with the power inverter while
watching television.
• Make sure that the antenna connected to your television provides an
adequate static-free signal and that you are using a good quality
cable between the antenna and the television.
• Move the television as far away from the power inverter as possible.
• Keep the cables between the battery and the power inverter as short
as possible and twist them together with about 2 to 3 twists per foot.
This minimizes radiated interference from the cables.
Condition
Poor contact
Battery voltage is too low
Shutdown on overload
Thermal shutdown
Receptacle has no power
7
®
Solution
Clean contact parts thoroughly
Start the engine to recharge the
battery. Replace the battery if
needed.
Reduce the inverter's wattage load
Allow the inverter to cool down by
reducing the load or turning it off for
a while.
Check the receptacle wiring.
User's Manual—Read before using this equipment
SPECIFICATIONS
All specifications are typical at nominal line, half load and 77ºF (25ºC)
unless otherwise noted. Specifications are subject to change without notice.
Name
Input
Output
Output frequency
Output waveform
Continuous power
Surge Power
Efficiency
Current drawn when no load
Battery low alarm
Battery low shutdown
Alarm and thermal shutdown
Internal DC fuse
External DC fuse
AC output sockets
USB output sockets
Power switch
Dimensions (L x W x H)
Net Weight
©2012 Wagan Corporation. All Rights Reserved.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
Description
12 V (10–15V) DC
110 V AC
60 Hz
Modified Sine Waveform
400 Watts
1,000 Watts
Approximately 90%
< 0.3 Amps
10.5 ± 0.5 V DC
10 ± 0.5 V DC
130ºF ± 10º (55ºC ± 5º)
35 Amps
None
Two 3-prong outlets
Two outlets: 5 V, 2.1 A
DC input ON/OFF control
5 x 4 x 2 inches
650 g
8

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Onduleur smart ac 400w usb+Smart ac 400w usb+

Table des Matières