Polk melee Mode D'emploi page 3

All manuals and user guides at all-guides.com
Xbox 360 Setup
®
Connect the digital optical cable (included) from the digital output on your Xbox 360
to the digital input on the DSP Amp. (note: Remove the protective caps from each
end of the optical cable before inserting them into the sockets.)
Connect the DSP Amp USB power cable to your Xbox 360 Console.
®
Connect the Audio Cable from the Audio Mixer to the DSP amplifier input
(round plug where DSP LED is located).
Plug the Audio Mixer into the Xbox 360 controller.
®
Insert the 3.5 mm connector into the Melee headset.
Use the Voice and Game Volume Control Knobs on the Audio
Mixer to adjust the overall volume level of headset output.