jbc BT Guide De Référence page 3

BT SOLDERING STATION
Design for general soldering.
BT-2BA 230V
BT-1BA 120V
Inluded:
- Control Unit
- Handpiece T245
- Cartridge C245-003
- Cartridge C245-007
BT-2SA 230V
BT-1SA 120V
Inluded:
- Control Unit
- Handpiece T210
- Cartridge C210-001
- Cartridge C210-008
INTRODUCING JBC TECHNOLOGY
The exclusive JBC heating system achieves an
exceptional thermal recovery, which increases
productivity, quality, reduces cost of ownership and
ensures fast return on investment.
Unequalled thermal response
An excellent soldering tool features instant thermal
response conceived by a high power/mass ratio.
A high power/mass ratio is being used to maintain
the tip's temperature as close as possible to the one
selected on the control unit, even when the thermal
load is significant. This is the formula needed to
perform high quality solderjoints and avoid cold
ones, protect the PCB that is being soldered and
increase productivity.
INTELLIGENT HEAT MANAGEMENT
The only time that a soldering tool should be at
working temperature is when it is actually being
used. JBC stations identify if and how a tool is being
used and depending on this switches the tool to
one of the following modes with their respective
temperatures:
Work mode: selected working temperature i.e.
350°C.
Sleep mode: during short periods of inactivity
the tool's temperature is being lowered to an
intermediate temperature i.e. 220°C.
JBC Tools save money by managing Heat
efficiently saving energy, time and improving
processes.
All manuals and user guides at all-guides.com
Technical specifications
- Temperature selection from 100 to 400°C or 200
- Power: 75W.
- Safety transformer, mains separator and double
- Input: 230V 50Hz. Output: 24V
- Input: 120V 60Hz. Output: 24V
- Total weight of unit: 2.6 Kgs (6,5lbs).
- Complies with CE standards on electrical safety,
- Equipotential connector and the tool tip are
OPERATION
LED lights
The LEDs indicate the station's different working
modes.
1. The station without a tool connected: The
green light IN USE flashes with the sequence
_
2. Tool out of the support: The green light IN USE
is permanently lit, indicating that the soldering iron
tip is at working temperature.
3. Tool in the support (sleep mode): The yellow
light SLEEP is permanently lit.
So that a tool goes into sleep mode, apart from
being placed in its support, the programmed sleep
temperature needs to be less than the temperature
on the dial or the prefixed temperature.
2
to 750ºF (±5%).
isolation, with integrated temperature protection fuse.
electromagnetic compatibility and antistatic
protection.
connected to station mains ground supply for
ESD protection.
This product should not be thrown in the
garbage.
Green LED (IN USE)
Yellow LED
(SLEEP)
Dial
.
ENGLISH