Publicité
Mechanical installation
4.4.4
Adjusting the air gap
Abb. 10
1. Loosen the bolts (10).
NOTICE
First correctly adjust the air gap with every 2nd bolt (10) / sleeve bolt (9)! The other three sleeve
bolts should be screwed into the stator so that they do not touch the flange or the bearing
shield. Then repeat the process with the other three bolts (10).
2. Slightly turn the sleeve bolts (9) using an open end spanner.
-
If the air gap is too large, screw into the stator (1.1).
-
If the air gap is too small, screw them out of the stator (1.1).
-
A 1/6 turn will change the air gap by approximately 0.15 mm.
3. Tighten the bolts (10), (for torques, see table
4. Check the air gap "s
5. Repeat the adjustment procedure if the deviation of "s
INTORQ | BA 14.0197 | 04/2016
WARNING
Danger: rotating parts!
Switch off the voltage. The drive system must be free of loads.
" near the bolts (10) with a feeler gauge, ("s
L
NOTICE
Only for brakes with manual release
❚ Additionally check the dimension "s" and adjust if necessary
17).
"
16).
LN
" is too large.
LN
30.
27
Publicité
