Senix LSPG-L2 Manuel D'instructions page 9

Attach Rear Trailing Shield
IMPORTANT: Do not operate unless an rear trailing shield is assembled in place.
1. Insert shield holders into mounting holes of mower deck (Figure 5).
2. Pass the rear trailing shield through two holders.
3. Ensure the rear trailing shield is hanging down.
Position Starter Rope and Cable
1. Hold the blade control against the upper handle (Figure 6).
2. Slowly pull starter rope handle from engine and slip starter rope into the rope
guide (Figure 6).
3. Use the cable clamp to secure the control cable to the handle (Figure 6).
IMPORTANT: To reduce wear and allow for proper operation, make sure to leave
some slack in the upper portion of the cable.
Attach Side Discharge Cover
Use the supplied nuts, bolts, and a 10 mm wrench to assemble the side discharge
cover to the mower deck (Figure 7).
WWW.SENIXTOOLS.COM
ASSEMBLY
Figure 5
Figure 6
Figure 7
9