JUNO T841 Instructions D'utilisation

Miniature Low Voltage Spotlights – for use with Juno T, TU,
R or V Trac systems only.
Assembly of a Low Voltage Spotlight Fixture
to Juno 12 Volt Electronic Transformer:
1. Connect Spotlight to Power Pack by inserting Spotlight Plug
into Power Pack Receptacle (Figure A).
2. Connect Spotlight to Power Pack by inserting Adapter Disc
into Power Pack opening and tuning clockwise until Lock Tab
engages (Figure B).
Installation of Transformer/Fixture Assembly
in Trac:
1. Power Pack switch should be in the "Off" (to right) position
(Figure C).
2. Insert Power Pack Contacts into trac channel (Figure D) and
rotate Power Pack 90˚ so that arrows on Power Pack Latch
point to polarity line on trac (Figure E). Latch pulls down to
clear trac and "snaps" into trac section, locking complete
assembly into position.
3. Power to trac can now be connected and switch can be put in
"On" (to left) position.
4. For Two Circuit Trac:
To install Spotlight and Power Pack on the first (lower) circuit
follow steps 1, 2 and 3 above. To install Spotlight and Power
Pack on second (upper) circuit insert a thin screwdriver under
Power Pack contact marked "P" and pull up (Figure F). Insert
plastic contact support (Figure G) supplied with two circuit
trac section by tipping and positioning under "P" contact. Install
complete assembly into trac section by following steps 1, 2 and
3 above.
Dimmer Data - Solid State Transformers
12V LAMPS OPERATED BY SOLID STATE ELECTRONIC
TRANSFORMERS (T538N) MAY BE USED WITH QUALITY
HOUSEHOLD DIMMERS OR A DIMMER SYSTEM DESIGNED
FOR NON-INDUCTIVE LOADS WITHOUT FEAR OF DAMAGE
TO THE TRANSFORMERS OR DIMMER.
For further information consult your dimmer manufacturer.
1300 S. Wolf Road • Des Plaines, IL 60018 • Phone 800-323-5068 • Visit us at www.acuitybrands.com/juno-trac
©2017 Acuity Brands Lighting, Inc.
INSTALLATION INSTRUCTIONS
Rev 9/17 P757A-CN 1 of 1