Publicité
Les langues disponibles
Les langues disponibles
Installation
Brick (all)
WARNING
!
If the thickness between the brick surface and sheathing exterior exceeds 4", the brick must be installed after
installing the brick standoff and BEFORE installing the termination. The termination cap will then secure to the
surface of the brick and secure to the brick standoff. For non-standard brick sizes, it is recommended to either use a
custom built brick standoff or mount the termination on the surface of the brick
Brick Standoff
Terminal
Refer to "venting requirements" and "venting installation"
sections in your appliance installation manual.
Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON L4M 0G8 Canada
Required for 4"/7":
•
Terminal (ST47U) (not supplied)
X 8
•
Brick Standoff (SOST47B) (supplied)
Required for 5"/8":
•
Terminal (ST58U-1) (not supplied)
•
Brick Standoff (SOST58B) (supplied)
1.0 Bend all 4 tabs outwards by 90 degrees.
2.0 Place the standoff in the framed opening, using the
tabs as guides.
3.0 Secure the standoff to the sheathing using the 8
long screws (supplied in brick standoff kit). The
screws should penetrate through the sheathing and
into the wall framing.
note:
Diagrams are for illustrative
purposes only. Installation must
comply with all local codes.
4.0 Attach the termination to the venting, see "pre-
installation" and "venting" sections of Silhouette
manual.
note:
All inner flex pipe and outer flex pipe
X 4
joints to the termination may be sealed
using high temperature red RTV silicone
W573-0002 (not supplied) or the high
temperature sealant W573-0007 Mill
Pac (not supplied). However, the high
temperature sealant W573-0007 Mill Pac
(not supplied) must be used on the joint
connecting the inner flex pipe and the
exhaust flue collar of the appliance.
5.0 Install the termination and venting from the outside
of the building, bringing the venting through the
opening in the wall.
6.0 Slide the terminal return flange over the standoff and
secure with 4 short screws (supplied in standoff kit).
7.0 Apply a bead ofs clear silicone to seal the edges of
the termination.
8.0 Finish around the brick standoff and termination with
brick.
1(866)820-8686
W415-2868 / A / 10.07.20
www.napoleon.com
Publicité
