Publicité
Les langues disponibles
Les langues disponibles
NETWORK MENU
Advanced Settings: PPPoE
Advanced Settings information for PPPoE protocol is provided in the table below.
Field
Use built-in IPv6
management
Force link
Obtain IPv6 address
Use default gateway
Use gateway metric
Use custom DNS
servers
VLAN tag value
VLAN priority
LCP echo failure
threshold
LCP echo interval
Host-Uniq tag content
Inactivity timeout
Override MTU
IP4table
ALD-16690
Value
Off | on;
Default: on
Off | on;
Default: off
Automatic | Disabled |
Manual;
Default: Automatic
Off | on;
Default: on
Integer;
Default: none
Ip4;
Default: none
Integer [0..7];
Default: none
Integer [0..4095];
Default: none
Integer;
Default: none
Integer;
Default: none
Raw hex-encoded bytes;
Default: none
Mac;
Default: none
Integer [1..1500];
Default: none
Integer [0..99999999];
Default: none
Description
Specifies whether to enable prefix delegation.
Specifies whether interface settings (IP, route, gateway) are
assigned to the interface regardless of the link being active
or only after the link has become active.
Defines behaviour for obtaining an IPv6 address.
When checked, creates a default route for the interface.
A metric specifies the priority of the gateway. The lower
the metric, the higher the priority (0 for highest priority).
Specifies custom DNS servers. If left empty, DNS servers
advertised by peer are used.
VLAN tag value.
VLAN priority.
Presumes peer to be dead after given amount of LCP echo
failures. Leave it at 0 to ignore failures.
Sends LCP echo requests at the given interval in seconds.
This function is only effective in conjunction with failure
threshold.
Leave empty unless your ISP require this.
Close inactive connection after the given amount of
seconds. Leave it at 0 to persist connection.
Maximum Transmission Unit (MTU) – specifies the largest
possible size of a data packet.
ID of the routing table in Routing tables page.
191
Publicité
