Axis T95A00 Guide D'installation page 5

AXIS T95A00/T95A10 Dome Housing
Tools not included
Phillips screw driver
*
RJ45 crimp tool
Adjustable wrench
*
The RJ45 connector is attached after the cable has been pulled through the cable gland.
Other required parts
Bracket
Power cable
Network cable
RJ45 connector
Soft cloth
Note:
Not all screws provided are required for all camera installations.
Installation
Prepare the following steps indoors before you proceed to do the installation outdoors. This will
save time at the installation site.
Top cover
Attach Universal Adaptor plate to camera
1. Remove the top cover of the housing (with four screws) from the housing using the 3mm allen
key.
2. For AXIS T95A00 Dome Housing only - remove the two connectors (with black and blue cables)
attached to the power supply on the Universal Adapter plate.
3. Loosen the three screws holding the Universal Adaptor plate. Slightly rotate and remove the
Universal Adaptor plate.
4. Attach the Universal Adaptor plate to the camera. For details see page 13.
All manuals and user guides at all-guides.com
see www.axis.com for available brackets and accessories
AWG20, 100-240 VAC cable (AXIS T95A00 Dome Housing)
AWG22, 24 VAC cable (AXIS T95A10 Dome Housing)
CAT 5 shielded twisted pair (STP) cable recommended
Recommended for protecting the dome while installing the housing
Black
cable
Blue
cable
Page 5
Universal
Adaptor plate