BorMann PRO BKD1355 Mode D'emploi page 4

EN
Pull out the power plug; Ensure that the mains connection is protected by at least a 10 A-rated fuse.
Avoid unintentional start up; Ensure that switch is turned off when plugging the plug into the socket.
Keep an eye on your work; A ways keep an eye on your machine and the object you are working on. Never use the machine when you are not
concentrating or are distracted. Never use the machine when you are under the influence Of alcohol or are taking medication.
Check the tool for damage; Before using the tool, safety devices and any slightly damaged parts must be carefully checked to ensure that they are in good
working order, visually examine the tool's power cable on a regular basis. All parts must be correctly assembled and meet all the conditions required to
ensure proper operation.
Unless otherwise specified In the operating instructions, any damaged safety devices and parts must be properly repaired or replaced by a
professionally recognized workshop. Never use tools with defective On/Off switches.
Warning: Using any plug-in tools and accessories other than those specified in these operating instructions can lead to injury.
Maximum workpiece size; Workpieces (max. 20 x 20 cm) may only be processed if they can be clamped securely on the drill table or in the vise.
Remaining hazards
The machine has been built using modern technology in accordance with recognized safety rules. Some remaining hazards however, may still exist.
- Long hair and loose clothing can be hazardous when the workpiece is rotating. Wear personal protective gear such as a hair net and tight fitting work
clothes.
- Wood chips and saw dust can be health hazard. Be sure to wear personal protective gear such as safety goggles and a dust mask. Use a vacuum exhaust
system.
- Thrown work-pieces lead to injury if the work piece is not properly secured fed, such as working without a limit stop,
- The use of incorrect or damaged mains cables can lead to injuries caused by electricity
- Even when all safety measures are taken, some remaining hazards which are not yet evident may still be present.
Remaining hazards can be minimized by following the instructions in "safety instructions" and in the entire operating manual.
Keep this safety information in a safe place.
Technical Data
Voltage/Frequency:
Power:
Speed settings:
Chuck size:
Spindle travel:
Swing:
Column Dia.:
Table tilt:
Table size:
Base size:
Max. Drill Capacity:
Machine Height:
Fig. 1
4
230 V/50 Hz, S1 250 W, S2 15min 350 W
350 W
5 Speed (550,950,1500,1950,2500 RPM)
1.5- 13 mm
50 mm
200 mm
46 mm
0-45° left or right
165*165 mm
276*178 mm
13 mm
580 mm
WWW.NIKOLAOUTOOLS.GR
* The manufacturer reserves the right to make minor changes to product
design and technical specifications without prior notice unless these changes
significantly affect the performance and safety of the products. The parts
described / illustrated in the pages of the manual that you hold in your hands
may also concern other models of the manufacturer's product line with similar
features and may not be included in the product you just acquired.
* To ensure the safety and reliability of the product and the warranty validity,
all repair, inspection, repair or replacement work, including maintenance and
special adjustments, must only be carried out by technicians of the authorized
service department of the manufacturer.
* Always use the product with the supplied equipment. Operation of the
product with non-provided equipment may cause malfunctions or even serious
injury or death. The manufacturer and the importer shall not be liable for
injuries and damages resulting from the use of non-conforming equipment.
Fig. 2
Spindle pipe