Denver Electronics CR-419 Manuel D'instructions page 4

LOCATION OF CONTROLS
5
4
3
2
1
1. ALARM 2/VOLUME+ BUTTON
2. ALARM 1/VOLUME- BUTTON
3. TIME SET/ SLEEP SET BUTTON
4. PRESET BUTTON
5. SPEAKER
6. SNOOZE BUTTON
7. MEMORY BUTTON
POWER SOURCE
Plug the AC line cord into AC 230V 50Hz power outlet. The unit is now working and the display
figures will blink to show you it is operating, but not yet set.
TO SET THE TIME
Long Press TIME SET/ SLEEP SET button to trigger TIME SET MODE and display will start
blinking. Press the REVERSE/HOUR button to set the Hour and the FORWARD/MINUTE button
to to set the Minute.
NOTES:
• Keep pressing the REVERSE/HOUR button or the FORWARD/MINUTE button if you run past
the correct time.
• Time is displayed in 24 hours mode.
TO SET THE ALARM
When device is "STANDBY OFF" mode,
• Press ALARM 1/VOLUME- button to turn Alarm 1 on or off. This is indicated by the Light
next to the Alarm 1 in display.
• Long press ALARM 1/VOLUME- button to set alarm 1's time. When the time display is
blinking after the long press, press the REVERSE/HOUR button to set the HOUR and the
FORWARD/MINUTE button to set the MINUTE.
Note: This is the same as setting up Alarm 2.
All manuals and user guides at all-guides.com
6
10
11
ENG-4
7
8
9
12
8. OFF/ON SWITCH
9. FORWARD/MINUTE BUTTON
10. REVERSE/HOUR BUTTON
11. LED DISPLAY
12. DC JACK
13. ANTENNA
14. BACKUP BATTERY COMPARTMENT
14
13