DVI STARLINE DVP22121 Instructions De Montage

STARLINE
ASSEMBLY INSTRUCTIONS
DVP22121
Warning
All electrical connections must be made according to local codes. If
you feel you do not have the experience necessary to do this, please
have your xture installed by a quali ed, licensed electrician.
Make sure to note the maximum recommended wattage for your light
xture.
DO NOT EXCEED THE RECOMMENDED WATTAGE:
DVP22121 - 2 x 20W G9 LED
Cleaning
We recommend that you use a mild detergent, such as dish washing
soap, and warm water to clean the glass and metal surfaces. After
cleaning, make sure to dry the fixture completely because moisture
will corrode the satin finish. Use a damp soft cloth to wipe o dust. DO
NOT use abrasive pads or cleaning materials.
During installation, some xtures may require subtle adjustments in
order for the xture to look as intended.
Tools
Phillips head screwdriver
Allen Key
If you have and questions,comments, or concerns
contact us at customerservice@dvi.lighting
DVI Lighting
120 Great Gulf Drive, Concord
Ontario, L4K 5W1 Canada
T: 1 855 384 5483
F: 1 855 384 8435
1
A
2
C
A. Connect the copper ground wire to ground wire - If you
only have two wires coming from the electrical box,
connect the xture's copper wire to the green ground
screw on the mounting plate.
B. Connect the white xture wire to white supply wire.
C. Connect the black xture wire to black supply wire.
B
5
These instructions are property of DVI Lighting. Do not copy or reproduce.
3
Fully seal around 4 edges of
backplate with silicone sealant
between backplate and wall to
prevent water infiltration.
Use an allan key to re-lamp
the fixture.
4