Philips AZ-2030 Mode D'emploi page 12

RECORDING
GENERAL INFORMATION ON RECORDING
• Recording is permissible insofar as copyright or other rights of
third parties are not infringed.
• This deck is not suitable for recording on CHROME (IEC II) or
METAL (IEC IV) type cassettes. For recording, use NORMAL type
cassettes (IEC I) on which the tabs have not yet been broken.
• The best recording level is set automatically. Altering the
VOLUME, INCREDIBLE SURROUND, ULTRABASS or ULTRA
HIGH CLARITY controls will not affect the recording in
progress.
• At the very beginning and end of the tape, no recording will take
place during the 7 seconds when the leader tape passes the
recorder heads.
• To protect a tape from accidental erasure, have the tape in front
of you and break out the left tab.
Recording on this side is no longer possible. If, however, you
wish to record over this side again, cover the tabs with a piece
of adhesive tape.
SYNCHRO START CD RECORDING
1. Select CD source.
2. Insert a CD and if desired, programme track numbers.
3. Press STOP•OPEN 9/ to open the cassette door.
4. Insert a suitable cassette into the cassette deck and close the
cassette door.
5. Press RECORD 0 to start recording.
– Playing of the CD programme starts automatically from the
beginning of the programme. It is not necessary to start the
CD player separately.
To select and record a particular passage within a track
• Press and hold down SEARCH ∞ or §
(for AZ2035 model only: or on the remote control ¡ or ™).
• When you recognize the passage you want, release
SEARCH ∞ or §.
• To pause CD playback press PLAY 2; (for AZ2035 model only:
or on the remote control 2;).
– Recording will begin from this exact point in the track when you
press RECORD 0.
6. For brief interruptions press PAUSE ;. To resume recording,
press PAUSE ; again.
7. To stop recording, press STOP•OPEN 9/.
12