Publicité
STORAGE BETWEEN USES
• Turn the control knob off.
• Disconnect the LP source.
• Store the fire pit in an area sheltered from direct contact with inclement weather (such as rain, sleet, hail,
snow, dust and debris).
• If desired, cover the fire pit to protect exterior surfaces and to help prevent build-up in air passages.
Note: Wait until the fire pit is cool before covering.
STORAGE DURING PERIODS OF EXTENDED INACTIVITY OR WHEN TRANSPORTING
• Turn the control knob off.
• Disconnect LP source and move to a secure, well-ventilated location outdoor.
• Store the fire pit in an area sheltered from direct contact with inclement weather (such as rain, sleet, hall,
snow, dust and debris).
• If desired, cover the fire pit to protect exterior surfaces and to help prevent build-up in air passages.
• Never leave the LP cylinder exposed to direct sunlight or excessive heat.
Note: Wait until fire pit is cool before covering.
SERVICE
Only a qualified service person should repair gas passages and associated components.
Caution: Always allow the fire pit to cool before attempting service.
PROBLEM
POSSIBLE CAUSE
Propane cylinder is empty
Burner won't light
Blockage in orifice
Control knob is not in "ON" position
Gas pressure is low
Outdoor temperature is less than 40°F
Burner flame is low
and tank is less than 1/4 % full
Control knob fully on
Carbon build-up
Dirt or film on burner
Thick black smoke
Blockage in burner
All manuals and user guides at all-guides.com
Troubleshooting
CORRECTIVE ACTION
Replace propane cylinder
Clear blockage
Turn control knob to "ON"
Turn cylinder valve off and re-fill the cylinder
Use a full cylinder
Check burner and orifices for blockage
Clean burner
Remove blockage and clean burner inside and outside
-12-
Publicité
