Bercomac 701103 Manuel D'instructions

UNIVERSAL REAR COUNTERWEIGHT SUPPORT #701103
NOTE: Counterweights are sold separately.
a)
Install the support angle (item 11) on top link (item 18) with a 5/8'' pin (item 15) and secure with 3mm hair pin (item 19)
at each end. Hold in place temporarily using two hex bolts 1/2 x 1-1/2'' (item 6), lockwashers & nuts to enable
adjustments later.
b) Place the counterweight support (item 4) on top of tractor tow hitch using 1/2 X 1-1/2'' bolt (item 6) flatwasher, lockwasher and
nut.
c) Choose the best place to drill a hole to attach the support angle (item 11). You can install the support angle towards the inside
or towards the outside. You can also use the extensions (item 12) if required. Attach them with 5/8 X 1'' bolt (item 10) lock
washer and nut.
d) Drill 4 holes 11/32'' diameter on the back of the tractor and secure the support angle (item 11) with 5/16 X 3/4'' bolts (item 17)
and flange nuts.
e) Install the 3/8 X 1 1/4'' roll pin (item 5) on each end of counterweight support (item 4).
f) Install the counterweights (item 1) on the support (item 4) and secure underneath with 3/4'' pin (item 2) and two 4 mm hair pins
(item 3).
WARNING : Weights MUST be at all times secured in place by the pin (item 2) to avoid risk of injury.
429-701103-I
INSTALLATION
Instructions
R-08152023