Felisatti VC25/1400 Instructions De Service page 7

▶ Do not leave the device without supervision. In case of longer
interruptions of work, pull the power plug.
Warning!
▶ Have repairs been made only by experts, e. g. the producer's
service. Use original spare parts only.
▶ Improperly repaired devices pose a hazard for the user.
2 Before use.
When unpacking, check that the unit is complete and shows no
signs of transport damage.
Read all the information carefully. They contain important advice
about how to use the unit, safety, maintenance and care. Please
keep these operating instructions somewhere safe and pass on
to any subsequent owners. We reserve the right to make design
and equipment changes.
3 Fields of application
▶ The vacuum device is designed for industrial use. Ideal in
combination with an electric tool, on building sites, in work-
shops, etc. For wet and drying suctioning.
4 Commissioning.
Switch the unit ON/OFF with the switch ②a in the top section ①
(or switch to automatic mode – see Section 4.1.).
4.1 Operating ield.
Depending on the unit coniguration, the following functions and
settings are available:
0 = Suction unit >off<
I = Suction unit >on<
A = Ready mode for ON/OFF automatic mode. (Suction unit is
switched ON/OFF by the electrical tool)
6
R = Filter cleaning function; in this switch setting the vibrator
is activated for approx. 10 sec. and then switches off again
automatically.
RA = Ready mode like "A" plus automatic ilter cleaning.
The power socket ②b is available for connecting an electrical
tool.
Caution!
The electrical tool must be switched off during connection. The
power socket is permanently supplied with voltage when the plug
is in the mains socket regardless of the switch setting. In switch
setting "0" the power socket could still be used as an extension
cable (e.g. for lights).
Connected load: Suction unit and connected unit max. 16 A.
The suction output can be adjusted steplessly using the rotating
speed setter ②d.
The suction openings of the electrical tools are not standardised.
There is an adapter available (rubber nozzle or rubber muff)
which can be shortened and adjusted to the respective electrical
tool.
5 Operation [wet and dry suctioning]
When the handle pipe is used, the secondary air valve can be
used to adjust the suction output.
5.1 Dry suctioning.
Only suction with a dry ilter, unit and accessories so that the
dust does not adhere and harden. We recommend using a paper
ilter bag if soot, cement, plaster, lour or similar substances are
suctioned. Always use the paper ilter bag in combination with the
ilter cartridges.
5.2 Wet suctioning.
Suction without a paper ilter bag. The ilter cassettes are suitable
for wet suctioning.
The installed sensor switches the motor off when the tank is
full. Empty the unit as outlined in Section 5.4. If the unit is not
switched off, the restarting safeguard remains effective. The unit
will only be ready for operation again after it has been switched
off and switched on again.
●Before emptying, irst remove the suction hose from the
liquid.
●Due to the high suction output and the streamlined shape of
the tank, a little water may escape from the hose after the
unit has been switched off.