Publicité
Les langues disponibles
Les langues disponibles
EN
Safety Instructions
General requirements
1.
Please carefully read the documents before installing, operating or maintaining the equipment. The documents are subject to change due
to product updates or other reasons.
2.
Do not put heavy objects on the equipment.
3.
Ensure that all cables and connectors are intact and dry before connecting to prevent electric shocks.
4.
Use insulation tools or wear personal protective equipment when you install or operate the equipment.
5.
Do not install or operate the equipment in extreme weather events such as lightning, snow, heavy rain, strong wind and so on.
6.
Do not damage, smear or rip off any warning labels on the equipment.
7.
Do not hit, pull, drag, squeeze or step on the equipment, or throw it into the 昀椀re, as there is risk of explosion.
8.
After installing, please clean the remains of the installation, such as boxes, clipped cable ties, ripped insulation materials, etc.
9.
Do not modify or repair the equipment, please contact our customer service or quali昀椀ed personnel if necessary.
10.
Use tools and the equipment correctly to prevent personal injuries and product damage.
11.
Understand the components and function of the grid-tied PV power system. Make sure that all electrical connections, and voltage and
frequency at the connection point meet the local microinverter grid-tie requirements and electrical standards.
12.
Make sure the screws are tightened to the speci昀椀ed torque during installation (M5*12: 30 Kgf*cm; ST5*12: 45 Kgf*cm; M6*20: 90
Kgf*cm).
13.
Make sure that the ground wire is tightly connected. The line diameter of ground wire should be ≥ 4 mm².
14.
It is strongly recommended to install an overcurrent circuit breaker between the equipment and the grid.
15.
The enclosure of the equipment may get more than 70 °C (158 °F) while in use. Do not touch it before it cools down. Also, always keep
the equipment out of reach of children and pets.
16.
The installation location should be convenient for you to put out the connectors.
17.
Before you pull out the AC (or battery) connector from the microinverter, disconnect the cable from the AC socket (or battery's) end.
18.
All operations including installation and maintenance, should be carried out by quali昀椀ed personnel. This device is not intended for
persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge or people unfamiliar with these
instructions.
19.
Personnel who plan to install or operate the product should receive training about electricity, understand all necessary safety
precautions, and be able to perform all installations and operations correctly following local regulation.
20.
It is strongly recommended that you ask a professional or a well-trained electrician to check or adapt the installation. Only quali昀椀ed
personnel can replace the product or its components (including software).
Environment requirements
1.
Make sure the equipment is installed, operated or stored in a well ventilated place.
Do not install or operate the equipment near 昀氀ammable, explosive, corrosive, caustic or moist sources.
2.
Do not expose the equipment to strong electromagnetic 昀椀elds to avoid radio interference.
3.
Explanation of symbols
Danger
Do not damage, smear or cover any warning lables on the equipment. All labels must be visible after installation.
Symbol
Explanation
Refer to the operation
instructions
Caution, hot surface
Caution, risk of danger
EN
Symbol
Explanation
Caution, risk of electric
shock; energy storage timed
discharge
Protective conductor terminal
Ingress Protection rating
Publicité
