Van Guard ULTI Bars - X2 Instructions De Montage page 5

4
Loosely secure the middle inner fixing brackets to the inside of the vehicle by inserting the M6 1/4 turn nut inserts (FX4025) into the positions shown in FIG.1. Then place the
middle inner bracket into place and loosely bolt into the M6 1/4 turn inserts using M6x20 hex bolts and M6 washers. Please note the cable trim (shown in FIG.2) may have to be
removed. This trim can be refitted after the inner bracket has been secured.
MIDDLE (ME0064)
MIDDLE / ME0064
MIDDLE / ME0064
5
Loosely secure the rear inner fixing brackets to the inside of the vehicle by inserting the M6 1/4 turn nut inserts (FX4025) into the positions shown below. Then place the rear
inner bracket in position and loosely bolt into the M6 1/4 turn inserts using M6x20 hex bolts and M6 washers.
LEFT (ME0066) RIGHT (ME0065)
LEFT / ME0066
RIGHT / ME0065
FIG.1
M6 1/4 TURN NUT INSERT LOCATIONS
FIG.2
TRIM MAY NEED REMOVING BEFORE FITTING. THIS
CAN BE RE-FITTED AFTWARDS.
M6 1/4 TURN NUT INSERT LOCATIONS
IN8099 - PAGE 5 OF 8