Profile VOLANTE Mode D'emploi page 21

1
PROGRAMMING
A
B
BEEP BEEP
C
BEEP BEEP
♫ ♫
D
NOTE :
When you replace or remove the batteries from the bell unit please always re-follow the above
steps to programme the bell.
2
DELETE PROGRAMME
To delete a programme, remove the batteries from the button and the bell. Press the button for 10
seconds. Leave both for 30 seconds.
To delete a programme, remove the bell from the electrical socket and remove the batteries from
the button(s). Press the button for 10 seconds. Leave both for 30 seconds.
3
PROGRAMMING MULTIPLE BELLS
Repeat steps 1A - 1C for all bells. Do this per bell in order to avoid interference.
Access the button by pressing in the tab on the side and
removing the insulating strip.
Slide open the lid on the back. Insert 2 alkaline batteries
into the battery compartment. The bell will not make a
sound. The bell is ready to learn and memorise the digital
code.
Plug the bell into an electrical socket. The bell will not
make a sound. The bell is ready to learn and memorise the
digital code.
Within a minute, push the button. The bell will play a ring-
tone. It is now programmed. Leave it for 5 minutes before
reusing it.
UK