Watts SentryPlus Alert Instructions D'installation

Installation Instructions
Watts BMS/IMS Freeze
Sensor Connection Kit
Read this Manual BEFORE using this equipment.
Failure to read and follow all safety and use infor-
mation can result in death, serious personal injury,
property damage, or damage to the equipment.
Keep this Manual for future reference.
You are required to consult the local building and plumbing codes prior
to installation. If the information in this manual is not consistent with
local building or plumbing codes, the local codes should be followed.
Inquire with governing authorities for additional local requirements.
Freeze sensor solely provides alerts about a possible freeze event
and cannot prevent a freeze event from occurring. User action is
required to prevent freeze conditions from causing product and/or
property damage.
Use smart and connected sensor technology on new
and existing installations to monitor temperature nearing
the freezing point. With the BMS/IMS Freeze Sensor
Connection Kit, the activated sensor relays a signal to
a building or an irrigation management system, helping
facility personnel take preventive action to reduce or
eliminate equipment replacement and repair. Freeze alerts
are distributed according to the BMS/IMS application.
NOTICE
Use of the freeze sensor does not replace the need to comply
with all required instructions, codes, and regulations related
to installation, operation, and maintenance of this product,
including the need to provide protection against a freeze event.
Watts is not responsible for the failure of alerts due to
connectivity or power issues.
IS-FZSensor-BMS/IMS