Technical Specifications; Gebruikershandleiding - Velleman VTSSC10N Mode D'emploi

Do not exercise excessive pressure on the tip while soldering, as this may cause damage to the tip.
Never clean the tip with a file or with abrasive materials.
Do not use flux containing chloride or acid. Use only resinous fluxes.
If an oxide film has formed, you should remove it by buffing carefully with a 600 – 800 grit emery cloth or
by using isopropyl alcohol and then applying a new protective layer of solder.
For new tips: set the temperature to 250 °C (482 °F). When the temperature is reached, tin the tip, and
allow it to idle for three minutes. Then set the desired soldering temperature and work normally.
Important: Remove and clean the tip daily. Remove excess solder from the barrel nut assembly when
installing a new tip, otherwise the tip may be fused to the heating element or to the retaining assembly.
9. Maintenance
Soldering tips can be replaced simply by unscrewing the barrel nut assembly. Turn off the station and allow
it to cool down first. You can damage the soldering station if you switch it on without the tip in place.
After removing the tip, blow out any oxide dust that may have formed in the tip receptacle. Be careful not
to get dust in your eyes. Replace the tip and tighten the screw. You can use pliers to avoid contact with hot
surfaces but use with caution because over-tightening may cause damage to the element or fuse the tip
to the element.
Clean the outer cover of the iron and station with a damp cloth and a small amount of liquid detergent.
Never submerge the unit in liquid or allow any liquid to enter the case of the station. Never use any solvent
to clean the case.
If the iron or station become faulty or, for some reason do not operate normally, return them to the service
department of your authorized dealer or service agent.
10.

Technical Specifications

max. heater power for soldering iron
temperature range
low-voltage iron
weight
dimensions
replacement bits
replacement soldering iron
Use this device with original accessories only. Velleman nv cannot be held responsible in the event
of damage or injury resulting from (incorrect) use of this device. For more info concerning this
product and the latest version of this manual, please visit our website www.velleman.eu. The
information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part of this
manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise without the
prior written consent of the copyright holder.
1. Inleiding
Aan alle ingezetenen van de Europese Unie
Belangrijke milieu-informatie betreffende dit product
Dit symbool op het toestel of de verpakking geeft aan dat, als het na zijn levenscyclus wordt
weggeworpen, dit toestel schade kan toebrengen aan het milieu. Gooi dit toestel (en eventuele
batterijen) niet bij het gewone huishoudelijke afval; het moet bij een gespecialiseerd bedrijf
terechtkomen voor recyclage. U moet dit toestel naar uw verdeler of naar een lokaal recyclagepunt
brengen. Respecteer de plaatselijke milieuwetgeving.
Hebt u vragen, contacteer dan de plaatselijke autoriteiten betreffend de verwijdering.
V. 02 – 06/02/2013
VTSSC10N
48 W
150 - 420 °C
24 V
1.75 kg
120 x 170 x 90 mm (without stand and iron)
BITC10N1 1.6 mm
BITC10N2 1.0 mm
BITC10N3 3.0 mm
BITC10N4 2.0 mm
VTSSC10N/SP

GEBRUIKERSHANDLEIDING

5 ©Velleman nv