ECOPOSTURAL C3260 Instructions page 6

All manuals and user guides at all-guides.com
English
STATIONARY TABLE
INSTRUCTIONS
Ecopostural thanks you for buying our products. The item you have just purchased has been
manufactured according to high quality and security standard. Follow the below-mentioned instructions
carefully in order to be able to make use of it for a long time. Click on to the TECHNICAL INFORMATION
section in our website www.ecopostural.com
* Our company will decline any responsibility for any damage occurred if ignoring these
instructions.
1) GENERAL INSTRUCTIONS
- Please read carefully the operating and safety instructions before using our products. These instructions
must be adhered to. Keep the instructions booklet for further check-ups.
- Familiarize yourself with the precise use of the item.
- If the table is handled by unqualified people in an inappropriate way or not according to the intended
purpose, the use of the examination table may be dangerous. Be careful when handling the table as there
is a risk of being trapped by the mobile parts and because of sudden movements.
- Regularly check the table entirely to find any sign of malfunction or damage.
- Worn or damaged pieces must be solely replaced by original pieces by the manufacturer depending on
the table model.
- All components parts or accessories should be fitted or fixed in according to the special manufacturer's
instructions. Any spare / replacement component part different to the manufacturer's could be dangerous
for the people involved in the table handling.
* Notice: The use of non original pieces or the alteration of the item will incur in a loss of validity of
the manufacturer's guarantee, instructions and Declaration of Conformity.
2) OPERATING INSTRUCTIONS
a) Installing
The table must lean on a solid and level ground.
The table is adjusted at the minimum height when being packed. Follow the "Height adjustment"
instructions for a tight-fitting.
Right below the upholstery you will find a box containing the wooden wedges aimed at shimming the table.
Notice: in certain floor surfaces the table legs might leave marks after a prolonged contact. Check the
technical specifications of the floor manufacturer to avoid any trouble.
b) Load capacity
This item has been tested to support a MAXIMUM STATIC WEIGHT of 135 Kg evenly distributed all over.
Absolutely avoid leaning on the very edge for support as it may tilt over.
If pressure on a reduced area exceeds the allowed weight, the table upholstery could split up. Keep the
patients from getting on by their knees.
To get on the table the patient must seat at the middle of the table, raise his legs and lean on his side.
Then, he can lie down. Weight must necessarily be distributed evenly and not concentrated on either side
of the table.
When getting down the table different procedures apply depending on the position of the patient.
Therefore, if he is lying down (prone position) he has to slide gently towards the middle of the table, lean
6