Jeulin 571 023 Mode D'emploi page 13

Observation
CCD camera
Ref :
571 023
ENGLISH
All manuals and user guides at all-guides.com
7 Working with the camera
TAKING THE CAMERA INTO USE WITH A MICROSCOPE AND TV /
MONITOR.
7.1 Setting up the microscope
Set up the microscope with a slide for normal use.
Focus sharply on the specimen using the lowest magnification.
Set the phototube to receive the image.
7.2 Setting up the camera
Take a camera out of its packing and remove the lens cap.
Screw the adapter (optional) into the front thread of the camera.
Connect the BNC or YC (SVHS) cable in the right connector on the back panel
of the camera.
Connect the plug transformer (DC 12V) to the mains supply, and the other side
to the "power in" connector on the back panel of the camera.
Carefully slide the camera with adapter into the photo tube of the microscope.
7.3 Connection to a TV or video-monitor
Connect the camera cable with the BNC plug to the "video in" connector on the
back panel of the camera. Use the BNC / Cinch adapter when the monitor has
a Cinch connector.
Connect the monitor to the mains supply and switch it on.
On a TV, the video channel (0) should be selected.
7.5 Backfocus adjustment
The front of the camera has a CS mount with screw thread. This ring is
adjustable in height against the sensor. Release the ring by loosening the set
screw by means of the allen key. Now take a flat driver, insert it into the ring to
adjust its height. Than tighten the set screw again. Bu doing this, one can
change the working distance of the objective used, or one can adjust the
infinity setting.
12