Marmitek PROGUARD800 Série Guide Utilisateur page 3

SAFETY WARNINGS
• The wiring of your electrical installation is live (230 V) and extremely dangerous.
Never connect the module when plugged into the mains. Always turn off the main
switch before starting the installation.
• This product is for professional use and should be installed by a certified installer.
• To prevent short circuits, this product should only be used inside and only in dry
spaces. Do not expose the components to rain or moisture. Do not use the product
close to a bath, swimming pool etc.
• Do not expose the components of your systems to extremely high temperatures
or bright light sources.
• In case of improper usage or if you have altered and repaired the product
yourself, all guarantees expire. Marmitek does not accept responsibility in the case
of improper usage of the product or when the product is used for purposes other
than specified. Marmitek does not accept responsibility for additional damage other
than covered by the legal product responsibility.
• This product is not a toy. Keep out of reach of children.
• Automatic switching devices provide comfort, but can also be dangerous. They
can surprise people or can ignite clothing hanging over an electric heat source.
Please be careful and take appropriate measures to avoid accidents.
INTRODUCTION
This product
ProGuard800 series, and operates together with
the ProGuard800 alarm system. When you wish to
know more about the complete system, its
possibilities and its settings, then you can check
out the installation
www.marmitek.com.
GSM Module (GSM800)
The GSM module enables the control panel to
communicate via cellular networks. This offers the
ability to send or receive SMS messages, perform
up/downloading, implement cellular 2-way voice
applications.
1. SIM card holder
2. SIM card release
3. Status LED
4. Flash programming connector
5. Flat-cable interface connector to Main Board
GSM800
is a part of
manual
the Marmitek
or visit
Figure 1.6: Cellular Communications Module
2