Thermor 312TX Installation

312TX
Indoor/Outdoor Wireless Thermometer
and Hygrometer
Setting up Second or Third Remote Sensor
NOTE: To setup the additional sensor, bring the monitor
close to the sensor.
1. Remove the back of the sensor as shown in the main
instruction manual.
2. Before inserting the batteries into the sensor, ensure
the correct channel is selected (see sensor diagram in
main instruction manual for location of channel switch).
3. Insert the batteries.
4. The transmission light will flash on the remote sensor
indicating that the signal has been sent to the monitor.
Once the monitor receives the signal, it will display the
current outdoor temperature on the channel chosen.
5. To setup a third sensor, follow the steps above.
For more information on the Indoor/Outdoor Wireless
Thermometer and Hygrometer please refer back to the main
instruction manual that came with your unit.
16975 Leslie Street
Newmarket, ON L3Y 9A1
www.biosexactly.com
TH2047_051710
All manuals and user guides at all-guides.com