Georgia-Pacific Jumbo Jr. Instructions D'installation

Jumbo Jr.
Two-Roll Bathroom Dispenser
Installation Instructions
EN
Step One: Unpacking the Dispenser
1 Jumbo Jr. Two Roll Bathroom Dispenser
Dispenser Key
If anything is missing from the above list, please call 1-866-HELLOGP (1-866-435-5647)
Step Two: Recommended Installation Location
1. Position the center of the dispenser 9.5" to 12" above the toilet seat.
2. Position center of dispenser 2" to 5" from the front of the toilet.
Step Three: Mounting the dispenser
1. Locate the screw holes in the back plate of the dispenser
that will most reliably secure the dispenser to the wall for your application.
2. Mark location for screw holes on wall using
dispenser and a tape measure.
3. Use good mounting practices to accurately
pre-drill pilot holes for screws.
4. Hold dispenser to wall and ensure pilot holes
align with dispenser.
5. Fasten screws to wall, leaving about ¼ inch
between the wall and screw head.
6. Ensure that dispenser is level and functional before tightening screws to
prevent dispenser from moving.
If you are experiencing any problems with this dispenser, please call 1-866-HELLO GP (1-866-435-5647).
©2011 Georgia-Pacific Consumer Products LP. All rights reserved. The Georgia-Pacific logo, and all trademarks are owned by or licensed to Georgia-Pacific Consumer Products LP.
All manuals and user guides at all-guides.com
Before You Begin
TOOLS AND SUPPLIES
• Screwdriver
• Power Drill
• Pencil or Pen
• Tape Measure
• Level (recommended)
• 4 ea. 1 Inch Screws
. Choose the holes
1
1