Publicité
Les langues disponibles
Les langues disponibles
CAMERA-MONITOR WARNINGS!
1. Camera/Monitor system aids in the use of, but does not replace vehicle
side/rear-view mirrors.
2. Objects in Camera/Monitor view are closer than they appear.
When backing up, processed cautiously and be prepared to stop.
IMPORTANT NOTE:
To comply with the FCC RF exposure compliance requirements, the antenna(s) used
for this transmitter must be installed to provide a separation distance of at least 20 cm
from all persons and must not be co-located or operating in conjunction with any other
antenna or transmitter. No change to the antenna or the device is permitted.
Any change to the antenna or the device could result in the device exceeding the RF
exposure requirements and void user's authority to operate the device.
NOTICE 1 :
The changes or modifi cations not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTICE 2:
Our WiSight wireless technology operates at nearly the same performance level as
a wired system. However, slight delays and signal reductions are possible due to
application or environmental factors.
It is recommended to maintain at least three feet in between any RF transmitting/
receiving devices including the WiSight components. This can include, but not limited
to, in-vehicle Wi-Fi systems, personal Wi-Fi hotspots, Bluetooth devices or additional
wireless monitors & cameras.
If you have a Voyager WiSight Digital Wireless Observation System along with any other
device that transmits or receives and you are experiencing diffi culty in operating the
system, the device(s) may be too close to either the WiSight Monitor or Camera.
Change the placement to at least three feet between devices and re-test for proper
operation.
T
S
ROUBLE
HOOTING
Monitor will not turn on.
Monitor display "No Signal".
Intermittent reception.
For further technical support call: 1-877-305-0445
- Check power cord connection at monitor
and 12VDC socket.
- Check fuse in cigarette socket adapter.
- Check 12VDC power at camera.
- Make sure antenna is tight and pointed
correctly.
- Make sure monitor is set to AV1.
- Try manually pairing the system.
see pairing Process for instructions.
- Make sure antenna is tight and installed
vertically.
EN-03
Publicité
